Esp guitar dating vertigem dublado online dating
[...] When [the YBA-1] ran on 7027s, it was a rock machine (think Black Crows, Zep, etc.).
It probably has a bit less bottom end and more mids and highs now. It must have been one of the last YBA-1 Traynors made.
A YBA-1 has a nominal 8 ohm output, and the two speaker jacks are wired in parallel.
Bass-Masters are identical in appearance to the Voice Master/Signature; Middle versions: Solid-state rectifiers started showing up in approximately mid 1966.] 0 [used], very early model, the serial number is 0278, which places it in 1966, uses 6CA7 tubes as specified in the tube chart, no tube rectifier, and the marshall style phenolic turret board, also, it has the hole in the chassis for the tube rectifier socket, but it is blocked with a circular steel plate, the 5 volt rectifier heater winding at the power tranny is cut about 2 inches out, December 1998 Rating Very good one. I have a 1977 YBA1 with a matching YT-15 cabinet [...]. It's probably not worth a tird as a collector's item but this amp really screams. I rate my YRM-1 second to my YBA-1, because it does not have as much balls.This must have been one of the last real Traynor amps made... Also, my YBA-1 sounds great at all volumes, including low setttings. 1965 or 1966 YBA-1 Bass-Master (old wrap-around style case), logo 1965 or 1966 YBA-1 Bass-Master (old wrap-around style case), front view, angle 1965 or 1966 YBA-1 Bass-Master (old wrap-around style case), front view 1965 or 1966 YBA-1 Bass-Master (old wrap-around style case), back view 1966 YBA-1 Bass-Master, chassis 1966 YBA-1 Bass-Master, wiring 1968 YBA-1 Bass-Master (serial number 2xxx), front view, angle 1968 YBA-1 Bass-Master (serial number 2xxx), front view 1968 YBA-1 Bass-Master (serial number 2xxx), logo YBA-1 Bass-Master, catalog page YBA-1 Bass-Master, catalog page YBA-1 Bass-Master, schematic 10/1966 YBA-1 Bass-Master, schematic 6/1971-1974 YBA-1 Bass-Master, schematic 5/1974 - Please note: This schematic has a serious error in it.Features silvery grey grille cloth Yorkville [...] owns Dyna-Bass #0011 and [has] used it as a promotional tool.Sound - Reliability - Price CAD 5 [used], condition unknown, Scarborough, Ontario, Canada, February 7, 2001 Very hard to find. Dyna-Bass, front view, angle (apparently the same as the following) 1963 Dyna-Bass, serial number 0011, front view, angle Features Two channels, deep (bass), and bright (guitar); each has an attenuated and a normal gain input (like the old Marshalls); no reverb Volume control channel one, channel two; treble, bass, low range expander, high range expander (passive); the low range expander may sound like a mid-range, the hi range expander may sound like presence (on Marshalls or Fenders) to some (the section is a virtual clone of that of the Marshall JTM-45); standby switch; pilot light; ground and on/off switch; no fan One main speaker output, impedance is not indicated (runs fine using a cab of eight ohms, also often operated with four ohm loads), one "extension" speaker output also without indicated impedance.
More power and punch than Fender, less ruggedness than Marshall.